Columns

RSS

Amkor Technology Inc. needed a multichip die bonder to assemble large flip chip devices for semiconductor manufacturers. It selected Datacon North America Inc.’s 2200 apm + multichip die bonder.

Given Imaging contracted Scapa Medical to devise a way for reusable antennas to be placed onto the patient's skin and then be removed after 8 hours, without damaging the antenna or hurting the patient.

With the right mix of parts, processes, people and planning, cells can produce exciting results. But it doesn’t always work out that way.

Brock contacted Fluid Research Corp. for dispensing equipment to mix its foam bead technology.

Helwig Carbon Products Inc. uses EFD's Ultrasaver dispenser to apply adhesive to assemble carbon brushes.

To fabricate its Sinergia 40 racing yachts, Sinergia Composites relies on Vantico's Araldite 2022 methacrylate adhesives.

At the beginning of 2002, Cincinnati Test Systems Inc. (Cleves, OH) had an onslaught of orders for different kinds of instruments.

Spyraflo Inc. (Peachtree City, GA) manufactures specialty bearings that offer innovative ways for original equipment manufacturers and fabricators to reduce cost and enhance bearing performance.

Liquids can wreak havoc on electrical components. But thanks to a good coil form design, controlled molding conditions, and the use of the same material for the bobbin and outer shell, an encapsulated solenoid has been created that resists liquid penetration.

Once you have the lead, the only way a competitor can catch you—or pass you—is if you stand still.