Manufacturing Industry Top Stories

RSS

Wearable electronics initially trickled into the market with Dick Tracy-inspired watches and healthcare bracelets. They quickly gained momentum, however, and it wasn’t long before the wearables market exploded.

In the past, automobile manufacturers only required basic forms of leak testing to check standard subassemblies, such as, air conditioning, power train and cooling system components. Traditional hard-vacuum and accumulation methods were—and still are—used to test components such as radiators, evaporators, condensers, air-conditioner hoses, torque converters and valve bodies.

Employees at Fiat Chrysler’s Indiana Transmission Plant I (ITPI) in Kokomo, IN, have achieved something few in manufacturing can claim—they have logged 10 million hours, or a span of more than three years, without a lost-time injury.

Manufacturers increasingly need to join multiple sheets of lightweight materials. Clinching can do it quickly, consistently and cost-effectively.

Manufacturers today are producing a wider range of products than ever. Life cycles are shrinking and demand for customization is increasing. As a result, assembly lines must be as flexible as possible without compromising efficiency. That’s why companies producing everything from pumps to pistols and caskets to chainsaws depend on mixed-model assembly.

Since the introduction of Electrically Commutated Motors (ECMs) over fifty years ago, there has not been a substantial energy efficiency improvement in motor technology for commercial refrigeration applications that exceeds the current generation of available ECM products.

Harness design software interfaces with other software tools to reduce development time and prevent errors.

When routing a wiring harness in an aircraft, engineers should pay attention to the proximity of the wires to hydraulic lines, mechanical cables and other parts.

When the first issue of ASSEMBLY rolled off the printing press in October 1958, the jet age was just beginning. Aerospace manufacturers were busy churning out bigger, faster, quicker and lighter products for a wide range of commercial and military applications.

When it comes to developing new production tools and assembly processes, it’s hard to beat Boeing. The company has always been ahead of the curve implementing new technology on its assembly lines.